Grundig Heinzelmann Bedienungsanleitung Seite 24

MAIN OPERATION ____________________________
DAB+ RADIO
DAB mode receives DAB/DAB+ digital radio and
displays information about the station, stream and
track playing.
Scanning for stations
The first time you select DAB radio mode, or if
the station list is empty, the radio automatically
performs a full scan to see what stations are
available. You may also need to start a scan
manually to update the list of stations.
To start a scan manually, choose scan from menu.
Once the scan is complete, the radio shows a list
of available stations.
To remove stations that are listed but not
unavailable, choose Prune invalid. Turn the OK/
Scan knob or press UP/DN button on the remote
control to view a list of stations and press to select.
Once selected, the station plays and the screen
show information about station, track or show as
broadcast.
Rotate the OK/Scan knob or press UP/DN button
on the remote control to view the station list.
Settings
Dynamic range compression (DRC) If you are
listening to music with a high dynamic range in
a noisy environment, you may wish to compress
the audio dynamic range. This makes quiet sounds
louder, and loud sounds quieter. You can change
DRC as off, low or high.
Station order You can choose the order of the
DAB station list to be either Alphanumeric, or
Ensemble. Ensemble lists groups of stations that
are broadcast together on the same ensemble.
24 ENGLISH
FM RADIO
FM radio mode receives analogue radio from the
FM band and displays RDS (Radio Data System)
information about the station and where broadcast.
The first time you select FM radio mode, or if the
station list is empty, the device will run auto scan
and save the stations to the preset list.
To find a station, press the OK/Scan knob or press
OK button on the remote control.
The frequency display starts to run up as the
device scans the FM band. Alternatively, you can
scan up or down by rotating the OK/Scan knob.
Settings
If you select "No" for Strong stations only in scan
setting, FM scans stop at any available station.
This may result in a poor signal-to-noise ratio (hiss)
from weak stations. To change the scan setting to
stop only at stations with good signal strength,
select "Yes" after choosing Strong stations only.
In Audio setting, all stereo stations are reproduced
in stereo. For weak stations, this may result in a
poor signal-to-noise ratio (hiss). To play weak
stations in mono, select "Listen in mono only" and
then "YES".
BLUETOOTH
Pairing Bluetooth
Rotate the Standby/Mode knob to find Bluetooth
mode, or press the Mode button on the remote to
Bluetooth mode. Press the OK/Scan knob or press
OK button on the remote control to enter.
Press the Menu/Return button on the device or
the remote control to display menu. Press the
OK/Scan knob or press OK button on the remote
control while displaying "Setup Bluetooth" to
make Bluetooth discoverable. From your Bluetooth
device, search the 'Heinzelmann' to pairing. When