Safety Information; M Ovi Ng P Arts; Hot Surfaces - Zanotti FZ007 Gebrauchs- Und Wartungshandbuch

1.2 Maintenance
For the safety and upkeep of the refrigeration unit it is important that maintenance work is carried out
following the timing indicated by the manufacturer (see maintenance table).
Maintenance work, as well as repairs, must be carried out by ZANOTTI S.p.A. authorized repair shops.
1.3

Safety information

W ARNI NG
• If using the refrigeration unit in a closed environment, use only the "MAINS" function (keep the vehicle motor
strictly turned off in order to avoid discharged gas poisoning).
Ensure that there is a distance of at least 60 cm between the condenser and the ceiling, and adequate
•
external air circulation.
• Cleaning operations on the refrigeration unit are carried out with the system turned off and after waiting for
this to cool.
To clean, use a cloth dampened with detergent.
•
Do not use jets of water or steam under pressure as this could damage the system electrical parts.
•

M OVI NG P ARTS

• As a rule, do not carry out maintenance work while the refrigeration system is in motion, and take all
precautions to avoid unwanted start-ups.
· During maintenance or repair operations, pay attention to moving parts such as fans, belts and
•
pulleys.

HOT SURFACES

Do not use the refrigeration unit with fairing or panels open or dismantled.
•
• Do not obstruct condensation airflow in any way.
• At the end of each operation period, the compressor, the condenser and the high pressure piping will be
very hot. Avoid therefore any form of direct contact with these components during checking or repair
stages until they have cooled down.
• Check regularly that dust, detritus or foreign bodies do not block the air circulation around the radiator
core of the condenser and evaporator.
If necessary, clean the parts in question.
•
• Do not let children operate the refrigeration system.
21