Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
EN
7.1 Instructions for assembly
Follow the instructions for assembly.
Do not install in the zones 0+1+2
min 40cm
above the upper edge
of the basin
Side view - basin
1.
Firstly, prepare the final position of the mirror. The optimal way for choosing the right position is to place the mirror
on the required place on the wall and see if that suits you.
2.
With help of the other person mark the upper edge of aluminium frame on the wall. Do not mark the edge of the
mirror! (Aluminium frame of some mirror models is of a different size than glass of the mirror!). Draw a small horizontal line.
See the picture below.
glass
aluminium
frame
3.
60 mm under the line draw another line and using the water-level draw this line in a size of the mirror width. Doing
this you measured the height of the holes for screws (their horizontal position).
Mark the centre which you can measure by the sink or tap.
4.
Now it is important to know the screw pitch, their vertical position. (NIMCO offers a wide range of models and types
of mirrors of different size. This general manual does not indicate the pitch for each model. It is then important to measure
it.) The pitch is measured directly on the mirror. On the back side of the mirror there are holes in the aluminium frame for
vertical or horizontal attachment. (Warning! It is possible to attach the mirror horizontally or vertically.). Choose the correct
holes according to your choice. These are the round holes. Measure their pitch, the distance of their centre lines (x).
30
ZP 8000 - ZP 59999
ZP 8000V - ZP 59999V
Zone 2
Zone 1
Zone 0
Side view - bath
7.1 Instructions for assembly
ZP 8000 - ZP 59999
ZP 8000V - ZP 59999V
See the picture below.
5.
You measured the pitch of the holes for screws. Now you mark them as the intersection points on the horizontal line
on the wall that you already drew. Every intersection point is ½ of the measured pitch distant from the marked centre (½ X).
Check one more time if the total distance between intersection points on the wall (Y) corresponds with pitch of the holes on
the mirror (X).
6.
Drill the holes to the marked intersection points.
to the type of wall material!
If the base is suitable (it is the standard brick wall with standard plaster thickness) you can use wall plugs and screws inclu-
ded in the package. Put the wall plugs in the drilled holes and use the screws whereas their head and shank stick out (max
5 mm of the visible shank).
7.
Connect the connecting cable with the mains cable or junction box. It is recommended to work in a pair! For co-
nnecting the cables, you can use the terminal box of article number ZP01 (in the picture) or any other terminal box with
the suitable IP for bathroom furnishing. Before you start connecting the cables, make sure there is no electric power in the
supply cable! Connect the cable of the mirror to the electric power supply to conductors L, N and PE. Terminal box is not
included in the package. Use only recommended supply voltage 230 V AC, 50 Hz, L+N+PE with front fuse max. 16 A.
Use the correct drill and attachment components according
EN
31
Werbung
Inhaltsverzeichnis
