VONROC VC503DC Bersetzung Der Originalbetriebsanleitung Seite 7

The following charger of the can be used to charge
these batteries.
CD802AA Quick charger
The batteries of the VONROC VPOWER 20V battery
platform are interchangeable with all the VONROC
VPOWER 20V battery platform tools.
DESCRIPTION
The numbers in the text refer to the diagrams on
page 2-3.
1. Handle
2. Release button for dust cup
3. On/Off switch
4. Battery
5. Battery unlock button
6. Motor housing
7. Dust cup
8. Extension tube
9. Cushion nozzle
10. Joint nozzle
11. Holder for cushion nozzle/joint nozzle
12. Floor nozzle
13. Suction opening
14. Filter assembly
15. Filter cover part 1
16. Filter seal
17. Filter
18. Battery LED indicators button
19. Battery LED indicators
20. Charger
21. Charger LED indicators
22. Filter cover part 2
3. ASSEMBLY
Before any work on the power tool, remove
the battery.
The battery must be charged before first
use.
Inserting the battery into the machine (Fig. B)
Ensure that the exterior of the battery is
clean and dry before connecting to the
charger or machine.
1. Insert the battery (4) into the base of the
machine as shown in Fig. B.
2. Push the battery further forward until it clicks
into place.
WWW.VONROC.COM
Removing the battery from the machine (Fig. B)
1. Push the battery unlock button (5).
2. Pull the battery out of the machine like shown
in Fig. B.
Checking the battery charging status (Fig. C)
• To check the battery charge status, push the
button (18) on battery shortly.
• The battery has 3 lights indicating the charge
level, the more lights that burn, the more
charge the battery has left.
• When the lights are not burning it means
the battery is empty and must be charged
immediately.
Charging the battery with the charger (Fig. C)
1. Take the battery (4) from the machine.
2. Turn the battery (4) to upside down position and
slide it onto the charger (20) as shown in Fig. C.
3. Push the battery until it is fully pushed into the
slot.
4. Plug the charger plug into an electrical outlet
and wait for a while. The LED indicators on
the charger (21) will lighten up and show the
charger status.
The charger has 2 LED indicators (21) which
indicate the status of the charging process:
Red LED Status Green LED status
Off Off
Off On
On Off
• Fully charging the 2Ah battery may take up to
60 minutes.
• Fully charging the 4Ah battery may take up to
120 minutes.
After the battery is fully charged remove the
charger plug from the outlet and remove the
battery from the charger.
EN
Charger status
No power
Standby mode:
- No battery is
inserted or,
- Battery inserted
but charging has
finished
Battery charging in
progress
7