Safety Instructions - Scheppach gm 22 Originalanleitung

parts or spare parts. Spare parts are available at your scheppach speciality
retailer.
• On orders, please indicate our item numbers as well as the type and the year
of manufacture of the device
Always turn off electrical devices before using the digital goniometer.
• Put the goniometer flat on a reference surface, e.g. a circular saw bench, a
mitre-box saw or a planing table. On a band saw the blade is the reference
area.
• Turn on the goniometer and press ZERO in order to set it to 0.0°, calibrating
the reference surface (see fig.1).
• Arrest the device on the blade or on the planning arrester by using the
integrated magnets (see fig. 2). The goniometer should be held vertically to
the table for all measuring activities (see fig. 3).
• Any correct adjusted blade, truing block or band saw table is going to show
90°. If the display shows any other result than 90°, re-adjust your appliance
according to the corresponding instructions of the manufacturer (see fig. 4).
• Now you can press ZERO in order to set the goniometer to 0.0° and to
measure the angle of your blade, truing block or your band saw table (see
fig. 5 and 6).
• Replace the batteries by turning the lid on the back of the goniometer
counter clockwise (see fig. 7).

Safety instructions