Hazard Warnings; Remaining Risk Factors - Zipper Maschinen ZI-ASA305A Betriebsanleitung

11.6 Hazard Warnings

In spite of intended use, certain residual risks remain. Due to the design and construction of the
machine, dangerous situations may occur when handling the machines, which are marked as follows
in this operating manual:
A safety instruction designed in this way indicates an imminently hazardous situation
which, if not avoided, will result in death or serious injury.
Such a safety instruction indicates a potentially hazardous situation which, if not
avoided, may result in serious injury or even death.
A safety instruction designed in this way indicates a potentially hazardous situation
which, if not avoided, may result in minor or moderate injury.
A safety notice designed in this way indicates a potentially hazardous situation which,
if not avoided, may result in property damage.
Notwithstanding
suitability/training will remain the most important safety factor in the fault-free operation of the
machine. Safe operation depends foremost on you!

11.7 Remaining risk factors

Despite of correct and proper use and maintenance there remain some residual risk factors:
Hazard of injury or machine damage due to undetected machine defect
To minimize this risk, check the machine prior to every operation for loose screws and connections.
Check the motor noise, the collector tubes, chip container and impeller for eventual damage.
Damaged parts have to be replaced immediately, no operation of the machine in the meantime!
Hazard of electric shock
Undetected malfunctions in the power supply and/or the connected wood working machine might
result in electric shock when touching the machine. Ensure proper electric installation, and let it
check periodically by a trained electrician.
Danger due to unintended machine start-up
Eliminate this risk by disconnecting the machine before you perform any checks or activities on the
machine.
Hazard of inhaling toxic wood dust
Especially wood dust arising from chemically treated wood and/or lacquer/paint are harmful when
inhaled. Therefore let the dust settle for 10 Minutes before you empty the chop container and wear
a suitable breathing mask if required.
ZIPPER MASCHINEN GmbH www.Zipper-Maschinen.at
ZI-ASA305A
D A N G E R
W A R N I N G
C A U T I O N
N O T I C E
all safety regulations, your common sense
SAFETY
and appropriate technical
22