Learning Mode & Factory Settings - Velleman VM101 Bedienungsanleitung

Learning Mode & Factory settings
(*)Function 14 :Learning Mode (
)
Certain modes use delays stored in DELAY1 and DELAY2.
The learning mode allows you to store two different delays, DELAY1 and
DELAY2, each from 5s up to 2h. Default values are DELAY1 : 3 minutes and
DELAY2 : 1 minute. You can change these delays to suit your needs. The
delays are stored in EEPROM and will not be erased in case a power failure.
DELAY 1 :
LD4 flashes
Press mode button (LD3 will light)
At release, DELAY1 starts registering (LD2&LD3 flash alternately)
Wait until desired time has elapsed.
Briefly press mode button to stop recording (LD2 will flash)
To confirm DELAY1 press mode button again (LD1 lights)
DELAY 2 :
Press mode button (LD3 will light)
At release, DELAY2 starts registering (LD2&LD3 flash alternately)
Wait until the desired time has elapsed.
Briefly press mode button to stop recording (LD2 will flash)
To confirm DELAY2 press mode button again (LD1 lights)
Both delays are now stored in memory.
FUNCTION 15 : Restore factory settings )
(
LD1 & LD4 will flash alternately.
Push mode button to restore factory settings. LD1 will light for 3 seconds
while the default settings (DELAY1 = 3 min; DELAY2 = 1 min; FUNCTION 1)
are restored. If you have selected this setting by accident, you can override
the writing to memory by pressing the push button connected to the control
connector.
9