Connection - Velleman VM101 Bedienungsanleitung

CONNECTION

'Mode select'
push button.
Fuse.
'Load'- connector
(e.g. light fixture)
'AC power'- connector
All connections must be performed using solid-core wire of the
appropriate rating.
Installation must be done according to local regulations and
standards. If any doubt, consult a licensed technician.
This module is not suited for portable applications. The unit
must be wall-mounted or clicked on a DIN-rail.
The remote pushbuttons always carry a dangerous voltage and
must be rated for the applied AC voltage.
Never connect a transformer to the output while the
'synchronous motor speed control'-mode (mode 13) is active.
Most electronic transformer are not suited for dimming. Consult
your distributor.
'button pushed' indicator
LD1
LD2
LD3
LD4
IMPORTANT !
Connection
'MAX intensity'-
indicator
Dimming direction
(up/down)
'Idle' indication
Control connector
(e.g. push button )
5