Pioneer PDP-S20-LR Bedienungsanleitung Seite 3

INSTALLATION ON THE PLASMA
DISPLAY
CAUTION:
Attach the plasma display to the stand before installing
the speakers. See the Operating Instructions packed to-
gether with the stand for how to assemble the stand.
The illustrations show the holder for flush mounting, but
the explanations apply also for set back mounting.
Perform installation according to the following steps 1 to 2.
1 Attach the mounting fittings to the
speakers.
The illustration below shows the right speaker.
1 Align the convex portion of the holder for installing the
speakers on the right and left sides with the concave
portion of the speakers.
2 Fix the two points with screws.
3 Attach holders to the top and bottom of one speaker.
1
4 Similarly, attach two holders to
the top and bottom of the other
speaker.
2 Attach the speakers to the display.
The illustration below shows how to attach of the right speaker.
1 Fix the upper screw temporarily in advance to hang the
speaker on the display (In this case, leave a space of about
5 mm between the head of the screw and the display).
Downloaded from www.Manualslib.com
2 3
The display
5mm
manuals search engine
2 Hang the speaker on the upper screw.
3 Fix the lower screw temporarily.
4 Adjust the position of the speaker and then fix the upper
and lower screws firmly.
2
5 Attach the left speaker following the same procedure as
described above.
NOTE:
÷ When the display is to be moved after speaker
installation, do not hold the display by the speakers. Hold
the display with one hand on the bottom of the unit and
the other on the handle on the rear. Do not hold the
speakers and raise the display. This may cause the
deformation or damage of products.
English
4
3
3