Blaupunkt VCI201 Bedienungsanleitung Seite 7

VCI201
1. Suction nozzles:
1a) All-purpose floor suction brush
1b) 2-in-1 slotted nozzle
1c) Wet and dry floor suction brush
2. Metal tube
3. Hose holder
4. Hose
5. Switch
6. Cover with the motor
BEFORE FIRST USE
Remove all paper, cardboard, and films protecting the appliance and its parts.
Remove the wheels and accessories from the container.
Fix the wheels into the holes in the base of the vacuum cleaner (push them in).
BEFORE STARTING THE VACCUUM CLEANER
1. Make sure the EPA filter or bag is properly seated.
2. Connect the hose to the inlet or blow opening.
3. Install the tubes or the selected accessory on the hose.
4. Connect the vacuum cleaner to the power source.
5. Activate the vacuum cleaner with the main switch.
TIP: The vacuum cleaner can be used to collect water with a suction brush for both wet and dry
vacuuming (1c). Do not do it if a paper bag is installed. If there is too much water collected in the
container, it may escape between the container and the cover with the motor.
CLEANING AND MAINTENANCE
Regularly clean the suction cups, tube, and hose from hair and other impurities stuck inside.
Wipe the body with the motor using a slightly damp cloth, then wipe it dry.
The waste container can be cleaned under running water.
Clean the EPA filter regularly. It should be pre-cleaned by shaking it. It can be washed under running
water. Install the filter in the vacuum cleaner when it is completely dry.
It is recommended to change the bag, if it appears to be full or when the suction power has decreased.
If using a disposable bag, remove and discard it.
Replaceable Blaupunkt ACC054 paper bags and EPA Blaupunkt ACC055 filters are available.
7. Air outlet
8. Hose connector (inlet hole)
9. Cover latches
10. Handle
11. EPA filter
12. Filter attachment
13. Paper bag
14. Waste container
5