Using The Product; Power On / Power Off - BeeWi BBR110 Bedienungsanleitung

6

2. USING THE PRODUCT

2.1. Charging the receiver
The receiver must be fully charged for about 3 hours before using it.
Connect the USB cable provided to your PC and to the charging connector
(1) of the receiver. Use only the USB cable provided as using other devices
may damage the product.
When the indicator light is solid red, the receiver is charging. When the
light turns blue, the receiver is fully charged.
Note: the receiver can be used whilst charging.

2.2. Power On / Power Off

To power on the receiver, press and hold mFB for 4 seconds until the blue
LED indicator start blinking.
To power off the receiver, press and hold mFB for 4 seconds until the blue
LED indicator lights off.
Note: if the receiver is not connected to a Bluetooth source, it will automa-
tically power off after 10 minutes.
2.3. Pairing
Up to 7 devices can be paired to the BBR110 Receiver. To pair the unit
with a mobile device, refer to the Bluetooth pairing procedures in cor-
responding mobile phone or music player user manual and follow the
instructions below:
- make sure the BBR110 is powered off, then long press mFB for 6 se-
conds until the blue indicator remains steady and release the button. The
unit is in pairing mode.
- Select the device name "BeeWi BBR110" on the screen of the phone
and enter the pass key "0000" if requested to add the unit to the phone's
paired device list.
- When pairing is successful, the blue LED indicator is flashing rapidly
10 times.
- Confirm the connection on the phone.
- Check the connection by placing a call or playing the music from the
phone.
ENGLISH
Downloaded from www.Manualslib.com manuals search engine