Settings; Sound Settings; Panel Display Brightness; Change The Standby Time - IKEA UPPLEVA AA-1081823-2 Bedienungsanleitung

6 Settings

Sound settings

To get a surround sound effect the WIDE
mode can be turned on:
1� Press MENU on the sound system bar to
enter the menu options� Use </> to select
WIDE and press OK� Use the > button to
switch to On and press OK to confirm. Press
MENU to finish.
The subwoofer bass level can be adjusted to
fit your preference.
1� Press MENU on the on the sound system
bar to enter the menu options� Use </>
to select SUB and press OK� Use </> to
choose on a scale from -9 to 0 and press
OK to confirm. Press MENU to finish. The
higher the value, the more the bass will be
enhanced�

Panel display brightness

The panel display brightness can be
adjusted to suit different surroundings or
preferences� Follow these steps to change
the brightness�
1� Press MENU on the sound system bar to
enter the menu options� Use </> to select
BRIGHTNESS and press OK�
2� Use the </> buttons to select Off, Low,
AUTO or High and press OK to confirm.
Press MENU to finish. The High and Low
settings will give a high respectively low
brightness of the panel display while
with the Auto setting the panel display
will dim down after 15 seconds of non-
use� The Off setting will clear the display
of all information for a less distracting
appearance� The volume indicator ring
remains visible� Any operation will show the
display information for 15 seconds�

Change the standby time

To save energy the sound system will enter
standby automatically if there is no sound
playing� Follow these steps to adjust the
time before it enters standby� Select OFF
to prevent the system to enter standby by
itself�
1� Press MENU on the sound system bar to
enter the menu options� Use </> to select
AUTO STANDBY and press OK�
2� Use </> to select your preferred timing
and press OK to confirm. Press menu to finish.
Downloaded from www.Manualslib.com manuals search engine

UPPLEVA TV

We recommend you to do the following
setting if you have another TV (not
UPPLEVA*) connected with HDMI to the
UPPLEVA sound system� The setting makes
the TV and the UPPLEVA sound system
function in the best possible way together�
Follow these steps to set it up�
1� Press MENU on the sound system bar,
toggle to UPPLEVA TV and press OK�
2� Select No if you don't have an
TV*�
The setting "No" will prevent the sound
system to break in as the active source on
your TV when it is turned on�
The setting "Yes" must be used for UPPLEVA
TV*
You can change the setting back again if you
want to use the UPPLEVA sound system with
an UPPLEVA TV* at a later stage�
Follow these steps to set it up�
1� Press MENU on the sound system bar,
toggle to UPPLEVA TV and press OK�
2� Select Yes if you have an UPPLEVA TV*
*Only valid for these UPPLEVA TVs (stated
in article numbers):
402-565-98, 802-662-13, 202-565-99,
502-662-19, 802-566-00, 102-662-16,
602-566-01, 002-662-12, 002-565-81,
302-662-15, 602-565-78, 902-662-17�

Reset to default settings

Follow these steps to reset the sound
system to default settings�
1� Press MENU on the sound system bar to
enter the menu options� Use </> to select
RESET and press OK� The text Warning will
be shown on the panel display� Press OK�
2� Use </> to select Yes or No� Yes will
reset the sound system to factory settings
and No will jump back to menu options�
16
UPPLEVA