ACP AMANA MCS10TS Kurzanleitung Seite 2

Quick Start Reference Guide
Refer to Product Safety Manual for Safety Statements
DO NOT power spray
No metal pans
Numbered Pads
1
End of Cycle Beep
2
Key Beep Volume
3
Key Beep
4
Active Display
5
On-the Fly Cooking
6
Reset to Ready Mode
7
(some models)
Maximum Heating Time
8
Manual Operation
9
(some models)
Double Digit Operation
0
Clean Filter Message
Part No.20120202
Revised 7/12
Complete Owner's Manual available online
Can I change an option?
Options such as single or double pad programming, beep volume, and
maximum cooking time can be changed to suit individual preferences.
To change options:
1. Open oven door.
• If door is closed or STOP/RESET
complete, changes are discarded and microwave exits programming mode.
2. Press and hold pad 2 for approximately 5 seconds.
• This begins options mode.
• Microwave will beep and
3. Press number pad that controls option to be changed.
• See table below for options.
• Current option will display.
4. Press number pad again to change the option.
• Each time pad is pressed, option will change.
• Match code displayed with code for desired option.
5. Press START
• To change additional options, repeat steps 3 and 4.
• Changes appear after door is closed or STOP/RESET
pressed.
Display Options (Factory Settings in Bold)
OP:10 3 second beep.
OP:11 Continuous beep until door is opened.
OP:12 5 beep bursts until door is opened.
OP:20 Eliminates beep.
OP:21 Sets volume to low.
OP:22 Sets volume to medium.
OP:23 Sets volume to high.
OP:30 Prevents beep when pad is pressed.
OP:31 Allows beep when pad is pressed.
OP:40 15 seconds after oven door is opened, keyboard disabled.
OP:41 30 seconds after oven door is opened, keyboard disabled.
OP:42 1 minute after oven door is opened, keyboard disabled.
OP:43 2 minutes after oven door is opened, keyboard disabled.
OP:50 Prevents di erent pre-programmed pads to be activated during cooking.
Allows different pre-programmed pads to be activated during cooking.
OP:51
OP:60
Opening oven door does not reset oven back to ready mode.
OP:61
Opening oven door resets oven back to ready mode.
OP:70 Allows 60 minutes of heating time (some models).
OP:71 Allows 10 minutes of heating time.
OP:80 Allows use of preprogrammed pads only.
OP:81 Allows use of manual time entry and preprogrammed pads.
OP:90 Allows 10 (0-9) preprogrammed pads.
OP:91 Allows 100 (00-99) preprogrammed pads.
OP:00 Do not display message.
OP:01 Display message for 24 hours every 7 days.
OP:02 Display message for 24 hours every 30 days.
OP:03 Display message for 24 hours every 90 days.
F
or full product documentation visit:
www.acpsolutions.com
pad is pressed before programming is
0P:
displays.
pad to save changes.
pad is
 2012 ACP , Inc.
Cedar Rapids, Iowa 52404