Bluetooth Remote - Lupine Piko R Bedienungsanleitung

Bluetooth Remote

The Bluetooth Remote comes together with the Peppi V5 barmount (helmet & bikelights) or a bracelet
(Headlamps). On the bike, the best way to mount the remote is directly next to your grips so you have
full control an don't need to take off your hands while riding. The bracelet can be attached to a lot of
other things like ski poles, too.
Connecting the transmitter to the light:
By default, your lamp has already been connected to the transmitter.
For establishing a connection, the receiving mode in the lamp has to be activated.
Keep the lamp's button depressed the switch turns up
The receiving mode is active for 30 seconds. During this time, press the remote control's button until the
remote does light up green, too. release the button.

Several lamps and one transmitter:
It is possible to connect up to five lampheads to a single remote switch.
Several transmitters and one lamp:
Up to 4 transmitters may be connected to one lamp. The transmitter are stored in the lamp in turn. If you
want to use only one transmitter again to control your lamp, it might be necessary to connect this transmit-
ter up to 4 times with the lamp.
24 Piko R
green (after 15 sec) and let the button go.
Enable/Disable the remotes permanent LED light:
Keep the remote button depressed: The LEDs must turn green then blue again.
release the button.

Low battery warning from lamphead:
The remote mirrors the lamphead's low battery warning.
A fully charged or partly discharged battery will be shown by a red LED light.
Details see page 36.
There will be no warning if the remotes button cell itself is empty.
Low button cell:
With decreasing voltage, the remotes LEDs will also become weaker, to the point
the remote does not work anymore. Also cold temperature does reduce the
battery voltage.
Transmitter battery change:
For changing the battery, loosen all 4 screws at the bottom
of the transmitter using a T5 torx screw driver.
Insert the new CR 2016 button cell as shown and close
the transmitter again.
Tighten the screws until the blue sealing is visibly squeezed.
T5 torx screw driver: (Art.No. 137)
Bluetooth Remote
Piko R 25