Operation - Zipper Maschinen ZI-STB13T Betriebsanleitung

13.2 Operation

Switching ON:
 Belt cover and spindle guard must be closed!
 Push the ON-button (a).
Switching OFF:
 Push OFF-button (b).
Drehzahl und Riemenspannung einstellen:
1. Release the locking screw on the gear
cover with the allen key 5 mm.
2. Pull the locking screw and open the
gear cover.
3. Unfasten the thin nut M8 enough and
release the clamping screw with an
allen key 6 mm (not scope of delivery)
on the motor. See illustration 3.
4. Slide the motor forward a little to
release the load on the V-belts. See
below illustration 4.
5. Remove the V-belt between idle pulley
and motor pulley first, then slide idle
pulley towards the spindle pulley to
release the load on the V-belt between
idle pulley and spindle pulley. Remove
the second V-belt. See 4 & 5.
6. Place the two V-belts on the desired
assembly to reach the specified speed.
(see table)
7. Slide the motor back to tension the V-
belts again. The V-belts are correctly
tensioned when it gives way slightly
when pressed. Deflection distance of
belt is 5-10mm.
8. Tighten the clamping screw with an
allen key 6 mm (not scope of delivery)
on the motor again.
9. Close the gear cover. Fasten the
locking screw on the gear cover with
the allen key 5 mm.
As smaller the hole, as higher the rotation speed.
ZIPPER MASCHINEN GmbH www.Zipper-Maschinen.at
ZI-STB13T
OPERATION
a
b
25