Preparation Of The Surface; Power Supply; Cross-Section - Zipper Maschinen ZI-STB13T Betriebsanleitung

12.1.3 Preparation of the surface

Uncoated metal machine parts have been insulated with a greasy layer to inhibit corrosion.
This layer has to be removed. You can use standard solvents that do not damage the machine surface.
Do not use solvents based on nitrite, aggressive solvents like break cleaners or
scrubbing agents!
These damage the machine surface.

12.2 Power supply

When working with non-grounded machines:
Severe injury or even death may arise though electrocution!
Therefore: The machine must be operated at a grounded power socket
The connection of the machine to the electric power supply and the following checks have to be carried
out by a respectively trained electrician only.
1. The electronic connection of the machine is designated for operation with a grounded power
socket!
2. The mains supply must be secured with 16A:
3. If the connector plug doesn't fit or if it is defect, only qualified electricians may modify or re-
new it!
4. The grounding wire should be held in green-yellow.
5. Check, whether the feeding voltage and the Hz comply to the required values of the machine.
A deviation of feeding voltage of ±5% is allowed
6. After connecting, check the right running direction (400V)!
7. Make sure that a possible extension cord is in good condition and suitable for the transmission
of power. An undersized cord reduces the transmission of power and heats up.
8. A damaged cable must be replaced immediately
Operation is only allowed with safety switch against stray current
(RCD max. stray current of 30mA)
Use only permitted extension cable with cross-section the one in
Voltage
220 V-240 V
50 Hz
Plug 400V:
ZIPPER MASCHINEN GmbH www.Zipper-Maschinen.at
ZI-STB13T
N O T I C E
A T T E N T I O N
N O T I C E
N O T I C E
the following table declared.
Extension
<27 m
<44 m
<70 m
<105 m
5-wire:
with
N-conductor
ASSEMBLY

Cross-section

1,5 mm 2
2,5 mm 2
4,0 mm 2
6,0 mm 2
4-wire:
without
N-conductor
22