Operation; Operation Instructions - Zipper Maschinen ZI-STB16T Betriebsanleitung

Attach the drill
chuck key into the
key holder
The plier is optional,
with bolts, flat
washers and nuts
mounted on the
drilling bench or the
baseplate.
13

OPERATION

Device to be operated in a perfect state only. Inspect the device visually every time it is to be used.
Check in particular the safety equipment, electrical controls, electric cables and screwed connection for
damage and if tightened properly. Replace any damaged parts before operating the device.

13.1 Operation instructions

Perform all machine settings with the machine being
disconnected from the power supply!


 Before switching the machine on, make sure that the table-clamping lever is
firmly tightened
 Make sure that the bit is firmly clamped in the chuck
 Due to the height of its own weight is the fixation of the drill press to the ground
requirement for less-vibration work.
 Use a clip or clamping jaws to secure the piece to be drilled on the table
 Set the drill to speed answering a specific job
 Check the V-belts and tighten if necessary
 Overtightening the belts can cause the motor to bind and not start. It can also
damage motor bearings!
 In advanced wear of, replace V-belt
 V-belts and pulleys may not come into contact with grease, oil or other lubricants
 Loosen the V-belt for a long break

After drilling guide the spindle back to the top position by hand.
ZIPPER MASCHINEN GmbH www.Zipper-Maschinen.at
ZI-STB16T
Do not attempt to drill material with the surface other than flat unless a
suitable support is available!
Never switch the machine on while pressing the drill bit against the
material!
1. Remove the washer
and nut from the depth
stop. (see fig. 1)
2. Insert the depth stop
through the hole in the
fence. (see fig. 2)
3. Screw the depth stop
with washer and nut
that just had been
removed from step 1.
Centrally align the
depth stop into the
bore of the fence (see
fig. 3)
4. The home position of
pointer should be
0mm. (see fig. 4)
WARNING
ATTENTION
NOTICE
OPERATION
28