Low Battery Warning; Function Keys; Setup Menu - NAD HTR-M Benutzerhandbuch

BACKLIGHT
The HTRM is equipped with a backlight to increase visibility of the
HTRM in low light conditions. The HTRM also includes a light
sensor. By default, if you press any key on the remote and it senses
a low light condition, the back light will turn on. It will then turn
off again five seconds after no key has been pressed.
The behaviour and timeout for the backlight can be adjusted.
(Refer to the "HTRM Features" for further information.)

LOW BATTERY WARNING

If the HTRM senses the batteries are low, it will show "Low Batt"
on the second line of the LCD display whenever the remote is idle.
When this occurs the batteries should be replaced with new ones
immediately.
DEVICE SELECTOR KEYS
Simply pressing a DEVICE SELECTOR key will change the active
device on the HTRM. At this time, no IR commands will be
transmitted. The name of the selected device will be shown on the
first line of the LCD display.
Note: Any IR command can be associated with a DEVICE
SELECTOR key during "Copy" and "Learn" modes. Once the
associated function is assigned to the DEVICE SELECTOR key
pressing and holding the DEVICE SELECTOR key for more than
two seconds will send the associated command in addition to
the HTRM switching its active device.
NAVIGATION OF THE HTRM CONTROLS
MACRO KEYS
A macro can be associated with every key on the HTRM except for
the MACRO button itself. A total of 52 macros can be stored.
To execute a macro:
• Press the MACRO key. The first line of the LCD display will
show "MACRO".
• Within five seconds, press the key the macro is associated with.
• While the macro is executing a small "M" will be shown in the
top right of the LCD display. (refer to the Setup Menu section
for information on how to setup macros)

FUNCTION KEYS

There are 44 dedicated function keys on the HTRM. When you
press a function key, the name of the function will be shown on
the second line of the LCD display while the command is being
transmitted.
A/V PSET KEY
In the default configuration of the HTRM, the A/V PSET key acts
as a shift function when the AMP device is selected. Pressing the
A/V PSET key once will cause "Preset" to be displayed on the first
line of the LCD display. If within five seconds you then press a digit
0 - 9, the function for the corresponding A/V Preset will be
transmitted.
Note: The HTRM is an universal-type remote control, some NAD
receivers may not have more than 5 AV presets.

SETUP MENU

Press and hold the SETUP and ENTER keys for five seconds to
enter the Setup Menu. You cannot enter the setup menu if the
remote is currently displaying "Low Batt". This feature prevents
the setup from becoming corrupted under low battery conditions.
Please refer to Setup Navigation for the overall structure and basic
operation of the Setup Menu.
8