Blaupunkt GTw 190 A Installationsanleitung Seite 10

WARNING
!
1. Before starting the installation make sure to disconnect the vehicle's negative (-) battery power
cable. This will prevent possible electrical shock.
2. When wiring this unit please use the supplied connecting cords.
DO NOT remove the fuses. The protection circuit will not work in case of an emergency
3. GTw 190 A installed in the passenger compartment should be securely anchored in place.
4. Before drilling any mounting holes check behind where you want to drill the holes to make sure you
DO NOT drill into anything such as the gas line, brake lines or electrical wiring.
5. Do not install the GTw 190 A anywhere it can get wet.
6. Install the GTw 190 A in a location with good ventilation. Dot not place anything on top of the GTw
190 A to prevent airflow through the unit.
7. While driving keep your listening volume at a level wich does not mask important outside traffic
noises, such as emergency vehicles, etc.
8. High sound levels may cause permanent hearing loss.
CAUTION
!
1. This device is for 12 volt (-) negative ground. Please check your automobile to make sure it is this
type.
2. When routing leads and cords, secure them with cable retainers and electrican's adhesive tape or
shrink tubing wherever they may touch sharp edges. Kepp all wiring away from hot surfaces or hea-
ter outlets to prevent short circuits.
3. Refer to your car stereo's operation manual as well when installing speakers in your car.
Note:
If low frequency noise exists in head unit, noise may be amplified by GTw 190 A.