Maintenance Plan; Cleaning; Disposal; Trouble Shooting - Zipper Maschinen ZI-STB16T Betriebsanleitung

Clean your machine regularly after every usage – it prolongs the machines lifespan and is a pre-
requisite for a safe working environment.
Repair jobs shall be performed by respectively trained professionals only!

14.1 Maintenance plan

After each workshift:
 Apply a thin layer of oil on the column and the table
 Remove drill cuttings and metal chips
After 50 hours of operation
 Apply some fat on the angle drift

14.2 Cleaning

After each workshift the machine has to be cleaned. Remove chips etc. with a suitable tool. Do not
remove them by hand (cutting injury!). Remove dust as well.
The usage of certain solutions containing ingredients damaging metal surfaces as
well as the use of scrubbing agents will damage the machine surface!
Clean the machine surface with a wet cloth soaked in a mild detergent

14.3 Disposal

Do not dispose the machine in residual waste. Contact your local authorities for
information regarding the available disposal options. When you buy at your local dealer
for a replacement unit, the latter is obliged to exchange your old.
15

TROUBLE SHOOTING

BEFORE YOU START WORKING FOR THE ELIMINATION OF DEFECTS, DISCONNECT THE
MACHINE FROM THE POWER SUPPLY.
Trouble
Motor does not run
Loud noice when running
Drill runs erratically
Drill is hot and smokes
Motor runs but no rotation
or weak drilling power
MANY POTENTIAL SOURCES OF ERROR CAN BE CLEARED BY THE EXPERTLY CONNECTION TO
THE ELECTRICITY GRID.
Should you in necessary repairs not able to properly to perform or you
have not the prescribed training for it always attract a workshop to fix the
problem.
ZIPPER MASCHINEN GmbH www.Zipper-Maschinen.at
ZI-STB16T
NOTICE
NOTICE
Possible cause
 Incorrect power supply
 Switch defect
 Motor defect
 Safety switch activated
 Incorrect belt tension
 Drill chuck not assembled
correctly to arbour or one of them
is dirty
 Drill chuck jaws worn or damaged
 Spindle or boring is worn
 Too fast speed for material being
drilled
 Belt tension too low
 Pulley belt diry, slippery
NOTICE
TROUBLE SHOOTING
Solution
 Let it be checked by a trained
person
 Change
 Change
 Check the belt cover or
spindle guard (open?).
 Adjust belt tension (1cm rule)
 Check and adjust.
 Change drill chucj
 Check and replace if
nesessary
 Reduce speed use lubricants
 Tighten
 Clean
31