Herunterladen Inhalt Inhalt Diese Seite drucken

Maintenance - Zipper Maschinen ZI-STB16T Betriebsanleitung

Ständerbohrmaschine
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

  • DEUTSCH, seite 10
Adjusting the Drilling Bench (Height, tilt angle)
1. Release the locking handle
2. Rotate the height crank clockwise or
counter clockwise to desired height.
3. Pivot the drilling bench to the desired
position
4. Fasten the drilling bench again with
the locking handle.
5. You can also adjust the tilt angle of
the drilling bench. To do this, release
the retaining screw under the drilling
bench with an open end wrench
SW19 (not scope of delivery). Tilt the
drilling bench as described to the
right or left up to a max. of 45° and
secure the drilling bench again with
the retaining screw.
Setting drilling depth:
Adjust the depth stop to desired depth.
The depth is shown on the scale.
Changing the drill:
Fold the drill chuck guard up.
Release the retaining jaws of the drill chuck with the drill chuck key.
Remove the bit.
Insert a new bit.
Tighten the retaining jaws of the drill chuck with the drill chuck key.
Check that the bit is centred.
Fold the drill chuck guard down again.
Attach the drill chuck key back to the key holder.
Using a quick chuck:
Open the keyless chuck by turning in against rotation direction A and holding ring B until the
drill can be inserted.
Insert the drill.
Firmly tighten the collar of the keyless chuck by hand in rotation direction A and holding ring
B.
This automatically locks the drill chuck.
14

MAINTENANCE

Perform all maintenance machine settings with the machine being
disconnected from the power supply!
Serious injury due to unintentional or automatic activation of the machine!
The machine does not require extensive maintenance. If malfunctions and defects occur, let it be
serviced by trained persons only.
Before first operation as well as later on every 100 operation hours you should lubricate all connecting
parts (if required, remove beforehand with a brush all swarfs and dust).
Check regularly the condition of the security stickers. Replace them if required.
Check regularly the condition of the machine.
Store the machine in a closed, dry location.
ZIPPER MASCHINEN GmbH
www.Zipper-Maschinen.at
ZI-STB16T
ATTENTION
MAINTENANCE
30

Werbung

Inhaltsverzeichnis

Fehlerbehebung

loading

Inhaltsverzeichnis