Specifications - QSC Q-SYS DCIO-H Hardware-Benutzerhandbuch

Specifications

Specificatiion
Dimensions (HxWxD)
Line voltage requirements
Accessories included
Front Panel Controls and Indicators
Level adjust
Power On indicator
Display
Other
Rear Panel Connectors
Mic/Line input
Line Input
H.I./V.I. output
Line/Speaker Outputs
Relay outputs
AES3/EBU Inputs
Automation Inputs
Dual Gigabit Ethernet Q-LAN ports
HDMI input/output (DCIO-H only)
Power switch
IEC Power Connector
Audio Performance
A/D conversion
Frequency response
AES/EBU Digital Inputs (RJ45)
Input stage type
Input impedance
Input sample rate
HDMI Digital Inputs (DCIO-H only)
Bitstream support
Input sample rate
Mic/Line Input (XLR)
Input stage type
Input impedance
Max analog input level
Dynamic range (unweighted)
Dynamic range (A-weighted)
THD+N at 10 dB below clip (26dBu sens)
THD+N at 10 dB below clip (21dBu sens)
Input gain
CMRR typical 2
EIN
Phantom power voltage
Stereo Line Inputs
Connector
Input stage type
Value
1.75 (2 RU) x 19 x 11.2 inches (44 x 483 x 282.5 mm)
100 VAC – 240 VAC, 50/60 Hz
1m UL/CSA line cord, Euro-style connectors for outputs and relay connections
Rotary encoder
Blue LED
Monochrome 304x96 blue OLED graphics display
Momentary mute button
Mute LED (red)
Screen Navigation (Next) and ID buttons
XLR — Mic (+ phantom power) or line level
3.5 mm TRS
5-pin Euro-style (x1) – common GND
Line: 3-pin Euro-style, Speaker: 2-pin Euro-style
3-pin Euro-style (x4)
Ch. 1–16 (RJ45 x2)
RJ45, RS-232
LAN A, LAN B (RJ45 x2)
HDMI 2.0, Type A female connectors
Rocker switch
32-bit delta-sigma, 48 kHz
20 Hz to 20 kHz (+- .5dB)
Balanced input
110 ohms
44.1 kHz, 48 kHz or 96 kHz
8ch PCM, Dolby Digital Plus™ and DTS-HD®
44.1 kHz, 48 kHz (Dolby Digital Plus™)
All (PCM and DTS-HD®)
Active balanced input
2.2k Ohms
26 dBu
> 111 dB
> 114 dB
< 0.02%
< 0.003%
0 to 60dB in 1 dB steps
20 Hz to 20 kHz: > 50dB
< -122 dB
15V
3.5mm TRS mini jack
Unbalanced input
11
EN
TD-001532-00-A