Troubleshooting - Homelite HLM4614S Bedienungsanleitung

EN
DE
FR DE ES IT
FR EN ES IT
Deutsch (Übersetzung der originalen Anleitungen)

TROUBLESHOOTING

Problem
Handle not in correct Handle positioned incorrectly.
position.
Handle knobs not tightened.
Mower not starting. No petrol.
Starter rope is harder to pull now than
when it was new.
Mower hard to push. High grass, rear of mower housing and
blade dragging in heavy grass, or cut-
ting height too low.
Wheel assembly needs cleaning.
Mower vibrating at Blade is unbalanced.
higher speed.
Bent motor shaft.
Grass catcher not Discharge chute blocked
filling with grass, but
grass is being cut
from lawn.
PT NL SV DA NO FI
PT NL SV DA NO FI
English (Original instructions)
Possible cause
HU CS RU RO PL
HU CS RU RO PL SL
Check to be sure that lower part of handle is pushed
fully back and snapped into proper position.
Tighten handle knobs.
Fill mower with petrol. If mower still does not start,
contact a servicing dealer.
Wait 15 minutes, then try starting mower again. Do not
prime before attempting to start.
Contact a servicing dealer.
Raise cutting height.
Clean wheel assembly. See Drive Gear Maintenance.
Replace blade.
Stop the engine, disconnect the spark plug wire from the
spark plug, and inspect for damage. Have repaired by
an authorized service center before restarting.
Stop engine, wait for it to stop, remove spark plug.
Remove grass catcher and lift discharge chute cover.
Beware of sharp blade, avoid contact. Remove debris
from the discharge chute.
21 21
SL HR ET LT LV SK BG
HR ET LT LV SK BG
Solution