Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Prior to Operation
A. Put the unit in proper location: complying with the requirements below can help
the unit achieve its best performance.
≥20cm
B.
Supply power should be in correspondence with the value on the nameplate.
Power outlet need be grounded.
C.
Take the main cord and plug it properly.
D.
Check and make sure that the space before air in/outlet is clear. Free wind flow
is the key to optimum performance and energy conservation.
E.
Push down air deflector before turning on the unit.
F.
If continues dehumidifying function need to be used for a long period, drainage.
≥50cm
≥20cm
pipe will be useful. Below are detailed operating procedures:
a. Open the revolving door for hose connector and take the plug off (see Figure1)
b. Plug drainage pipe with 14mm in diameter in the hose connector and tie it tense
in case of leaking (see Figure 2).
Figure1
OPERATION INSTRUCTIONS
A.
On/Off
a. Press "ON/OFF" key once while unit is energized,the air deflector swing automatically,
theunit begins to work.
b: Press "ON/OFF" key once againto switch the unit off, the air deflector will close
automatically.
Note: Let the unit rest for about 3 minutes after turned off, so that residual water on
condenser can flow into the tank. Pull out the plug when the unit is off for power
saving and safety.
B.
"Wind" speed key: Press once to change the fan speed between high fan and low fan.
Note: In automatic mode, this key is invalid.
C.
"Humidity" key: Under manual operation mode, the target humidity could be set between
a range of CO, 30%-80% in 5% per step.
Note: If there is no press up or down in 5s, the value will be kept.
D.
"Timer"key: Auto off timer (1-24 hours) can be set. Press the timer button, the timer
indicator "H" will be on, and the setting-up time will be flashed on the LCD display. The
original set value is 00. Press the Up/Down button in 5 seconds to set the auto off timer.
For each press, the set auto off time will be increased / decreased by 1 hour. The room
humidity will be displayed after 5 seconds. Auto off timer setting will be completed.
56 | 57
Figure2
GB
Werbung
Inhaltsverzeichnis
