User Interface - BeeWi BBZ302 Bedienungsanleitung

Make sure your Helicopter is turned on and select it in the list. The Helicopter will be
connected automatically and the control screen below displayed.

3.2. User Interface

When the Helicopter is connected, you can access the control screen below. By default the
control is motion and the trimmer is set to "0".
3.3. Operation
Gently push the throttle until the Helicopter engine turns on. Then keep the Helicopter on
the ground and try the direction commands to learn how to fly:
- To move forward, move the mobile device downwards
- To move backward, move the mobile device upwards
- To turn left, turn the mobile device leftwards
- To turn right, turn the mobile device rightwards
If the helicopter is drifting during the initial trial on the ground, it may be necessary to
adjust the direction trimmer using the Trim > key if the helicopter is drifting on the left, or
Trim < key if it is drifting on the right.
You can also simply use the buttons on the screen to control the Helicopter. To do so,
open the Menu bar using the Menu key of the phone, and tap on Touch/Motion key. A
confirmation message will appear on your screen. The controls are described next page:
Downloaded from www.Manualslib.com manuals search engine
1. Gas throttle
2. Direction wheel (only touch mode)
3. Trimmer
4. Status control: lives bar and battery meter
5. Emergency Stop
7
ENGLISH