Newton CVR640 17044 Bedienungsanleitung Seite 4

Connection to
Digisight/Hornet
Indication LEDs
The blue LED shows operational status of the unit.
The red LED shows problems with operation.
Is on
Blue LED:
Blinking
Blinking fast
Is on
Red LED:
Blinking fast
Note: should the video signal fall out during recording, the unit will stop recording;
the recorded part of a video clip will be saved automatically. After the video signal
restores, a new file will be recorded. The Red LED will light up showing that the
video signal was interrupted.
Installing the CVR640 on digital NV devices
џ
The CVR640 is fitted with a mount which enables the unit to be affixed to a
Weaver rail of your NV device.
џ If your NV device does not have a Weaver rail, the CVR640 can be attached
with the help of the supplied ¼" tripod socket adaptor. To do this, screw the
adaptor into the tripod socket of a digital NV device and attach the CVR640 to
the Weaver rail of the adaptor.
Software
The delivered memory card contains useful software which includes files as
follows:
џ CVR640 Driver – Driver software for the CVR640 which serves to connect the
unit to your PC. Install this driver before connection.
џ CVR640 Video Converter – Software for work in the mode of video recording to
a PC hard disc.
џ CVR640 Date_time setup – Software which enables setup of running time/date
and choice of recording format.
The CVR 640 is compatible with operating systems Windows XP, Windows Vista
and Windows 7.
Downloaded from www.Manualslib.com
The unit is 'On'
The unit is in recording mode
Low batteries
No input video signal
Memory card is full
manuals search engine
Note: It is recommended that before use of the CVR640 you should save the
supplied software to your PC. In case of loss of the software files, you can e-mail
us at support@yukonopticsglobal.com
Connection to PC
џ Start the CVR
џ Once you have uploaded the driver software, connect the CVR640 with the
supplied USB cable to your PC – the CVR640 will be detected as a removable
disc. The CVR640 can be turned off now – it will be powered via the USB.
џ With the help of Total Commander or another file manager you can handle the
SD card as a removable disc.
Pic. 2b
Note: Transmission speed from the memory card to the PC will not exceed
1Mb/sec.
Video recording to a PC hard disc
џ The CVR640 should be powered off. Use a USB cable to connect the CVR640
to the PC.
џ A window as shown in pic. 3 comes up. Now you will be able to handle the files
recorded on the unit's memory card. Press the "EXIT" button when finished.
Note: when the unit is attached to the PC in this mode, the SD memory card will
not be available via an explorer!
2
640.
Pic. 3