Charger - Zipper Maschinen ZI-RTR40V-AKKU Betriebsanleitung

Setting trimmer shaft length:
1. Turn the lock sleeve towards the 'unlock' symbol about half
a turn
2. Slide the trimmer shaft up or down to the desired length.
3. Lock it in position by turning the lock sleeve towards the
'lock' symbol
Setting mode:
A: Trimming
B: Edge trimming
1. Fit the wheel
2. Slide the locking knob down
3. Rotated the trimmer shaft
with the cutting head 90°
4. Release the locking knob
13.3

Charger

Charging the battery:
1. Connect the charger (1) to the power supply (AC outlet) 230 V / 50 Hz
2. Insert the battery (3) into the slots of the charger and slide into place until the battery locks
into place.
3. Charge the battery
4. Once the battery is fully charged remove the battery by pressing the lock button and sliding
out of the charger
5. Li-Ion batteries have nor memory effect. A partial charge will not damage the battery.
LED- indicator light (2):
LED lights red: Charger is ready to charge but no battery is connected.
LED flashes green: Battery is charging
LED lights green: Battery is fully charged and should be removed
LED flashes red: Battery is fault or overheated
ZIPPER MASCHINEN GmbH www.Zipper-Maschinen.at
ZI-RTR40V-AKKU
OPERATION
22