Kity 706 Originalanleitung Seite 19

Error Possible cause
Machine vibrates Clamping lever for height adjustment is not screwed tightly
Tool is not screwed tightly
Unclean cuts / wood burns Tool is blunt
Tool is not installed correctly
Fast wear and tear of tool Tool is not sharpened correctly
Covered wood (cement, sand, nails)
Motor heats up (one can no Different causes possible
longer touch it with bare hands,
it switches off constantly)
Machine stops Feed is too fast
Tool is blunt
The wood is lifted high by the Longitudinal stop is not parallel
rear part of the saw blade
Splitting wedge not in adjustment or sewing is too weak
Height adjustment of the spindle Threaded rod, toothed wheels, slide reals are polluted
is stiff
Clamping lever is not loosened
Machine vibrates Clamping lever for height adjustment is not screwed tightly
Tool is not screwed tightly
Unclean cuts / wood burns Tool is blunt
Tool is not installed correctly
Fast wear and tear of tool Tool is not sharpened correctly
Covered wood (cement, sand, nails)
Motor heats up (one can no Different causes possible
longer touch it with bare hands,
it switches off constantly)
Machine stops Feed is too fast
Tool is blunt
Height adjustment of the spindle Threaded rod, toothed wheels, slide reals are polluted
is stiff
Clamping lever is not loosened
Error search plan
Remedy
Saw
Tighten clamping lever
Tighten tool
Use sharp tools only
Check correct installation of the tool
Have the tool re-sharpened correctly / install new tool
Use clean wood only
Get it checked by an electrician
Reduce feed
Use sharp tools only
Readjust longitudinal stop
Readjust splitting wedge
Clean and lubricate components
Check and loosen clamping lever
Milling machine
Tighten clamping lever
Tighten tool
Use sharp tools only
Check correct installation of the tool
Have the tool re-sharpened correctly / install new tool
Use clean wood only
Get it checked by an electrician
Reduce feed
Use sharp tools only
Clean and lubricate components
Check and loosen clamping lever
19
D GB