Using The Controls - Hamilton Beach Summit Serie Bedienungsanleitung

Using the Controls

There are several blending options available, including AUTOBLEND, JUMP cycles, HIGH, or LOW cycles,
each with adjustable time settings. You may also store favorite settings for later use with the A, B, C, or D
buttons. For quick blending or to "freshen up" a beverage, use the PULSE button.
START, SCROLL TO SET
START, SCROLL TO SET
JUMP
LOW/HIGH 12 sec
HIGH
LOW
PULSE
A
D
6
Downloaded from www.Manualslib.com
AUTOBLEND 0
JUMP 4–12 sec
PULSE 0 sec
A B C D
STOP
MORE
manuals search engine
This is the default screen for the blender or if AUTOBLEND
is pressed . On setting 0, the blender senses when the drink
START
is finished and stops automatically. Press L or M button to
change to AUTOBLEND 1, 2, or 3 to add additional time.
Press START to run cycle.
Pressing JUMP displays the default jump cycle times (4
seconds at low, then 12 seconds at high). Press L or M
button to change the cycle length. Press START to
START
run cycle.
Pressing HIGH or LOW displays current run time for that
speed. Press L or M button to change cycle length. Press
START
START to run cycle.
Press and hold the PULSE button to run blender at HIGH
speed. Release to stop blender. Display will indicate
length of time the button is held.
These buttons allow you to save your favorite settings.
Select A, B, C, or D and press START to run cycle stored
START
in that location. To store a new cycle, adjust the speed and
time settings, then press and hold A, B, C, or D button for
3 seconds to save it to that location. A confirmation
message will show when cycle is SAVED.
NOTE: Saving a new cycle to a location will overwrite any
existing cycle in that location.
Pressing STOP will stop any cycle currently in use.
Pressing the MORE button displays cycle count screens
and other diagnostic information.