Frequency Channel - nedis WLTK1000BK Kurzanleitung

q
Up button A
q
Scan button A
3
Display A
Lamp button A
r
Belt clip A
Battery Compartment
t
A
Micro USB port A

Frequency channel

The product meets all required standards for radio equipment using PMR 446
frequencies as authorized. The use of this two-way radio product involves the
public airways and it's use may be subject to local laws or regulations. Contact
your radio licensing authority for more information.
Press to increase the volume.
Press and hold for 2 seconds to scan for radio
channels.
Press A
the display light.
Press and hold to switch on the lamp.
6
Hold the latch and move the belt clip upwards,
to remove the belt clip.
Slide the belt clip in to fasten the belt clip.
If the battery is low, the battery icon will flash
and a beep will sound to indicate that the
batteries must be recharged.
Remove the belt clip A
before opening the battery compartment A
Remove the batteries, if you do not use the
product for an extended period of time.
The product can be charged in the charging
i
base or via the Micro-USB port on the side of
the product.
It is recommended to switch off your radio
during charging.
1. Plug the micro USB cable A
2. Plug the other end of A
3. Plug the power adapter into a power outlet.
The battery icon on the display flashes to
indicate the product is being charged.
5 7 8
A A
i
USB port A
.
or power adapter.
7
9 q
A or A
to switch on
r
from the product
e
into the micro
e
into a computer
t
.