Reversing The Door - Hisense Combi RB343D4BW1 A+ Betriebsanweisung

9

Reversing the door

Reversing the door
The side at which the door opens can be
changed, from the right side (as supplied)
to the left side, if trequired.
Warning! When reversing the door, the
appliance must not be connected to the
mains. Ensure that the plug is removed
from the mains socket.
Tools you will need
Thin-blade
8mm socket wrench
screwdriver
Cross-shaped
Monkey wrench
screwdriver
Left Hinge Cover
Note: If required you may lay the
refrigerator on its back in order to gain
,
access to the base you should rest it
on soft foam packaging or similar
material to avoid damaging the
backboard of the refrigerator. To reverse
,
the door the following steps
generally recommended
1. Stand the refrigerator upright Open
the upper door to take out all door
racks (to avoid damage) and then close
.
the door
Putty knife
8mm wrench
are
.
.
Door racks
2. Use a putty knife or thin-blade
screwdriver to prize the screw hole cover
which is at the top left corner of the
refrigerator, and the upper hinge cover
which is at the top right corner of the
refrigerator.
screw hole cover
3. Unscrew the special flange self-tapping
screws which are used for fixing the right
upper hinge part by a 8mm socket driver
or a spanner (please support the upper
door with your hand when doing it) .
right upper hinge part
4.Remove the upper hinge axis, transfer it
to reversed side and tighten securely, then
put it in a safe place.
②
①
5. Remove the upper door from the
middle hinge by carefully lifting the door
straight up.
NOTE: When removing the door, watch
for washer(s) between the center hinge
and the bottom of the freezer door that
may stick to the door. Do not lose.
upper hinge
cover (right)
special flange
selftapping screws
③