Using The Product - nedis WLTK1010BK Kurzanleitung

•
In the event of a battery leaking, do not allow the liquid to come in contact
with the skin or eyes. If contact has been made, wash the affected area with
copious amounts of water and seek medical advice.
•
Seek medical advice immediately if a cell or a battery has been swallowed.
•
Do not install the battery in reverse polarity.
•
Observe the plus (+) and minus (–) marks on the cell, battery and equipment
and ensure correct use.
•
Do not short circuit.
•
Do not use any battery which is not designed for use with the equipment.
•
Battery usage by children should be supervised.
•
Always purchase the battery recommended by the product manufacturer for
the equipment.
•
Wipe the cell or battery terminals with a clean dry cloth if they become dirty.
• Use only the battery in the application for which it was intended as described
in this manual.
•
Non-rechargeable batteries are not to be recharged.
•
Do not use the battery if any part is damaged or defective. Replace a
damaged or defective battery immediately.
•
Do not dismantle, open or shred batteries.
•
When possible, remove the battery from the equipment when not in use.
•
Do not expose batteries to heat or fire. Avoid storage in direct sunlight.
•
Do not repair the product. If damaged, it must be properly disposed of.

Using the product

Power button A
7
Menu button A
Press and hold for 3 seconds to switch the
7
product on or off. A beep will sound.
Press 1x to select the channel.
Press 2x to select the CTCSS code.
Press 3x to select the DCS Sub-channels.
Press 4x to select the VOX settings.
Press 5x to select the call tone. (CA)
Press 6x to switch the key tone on or off. (TO)
Press 7x to switch the roger beep on or off. (RO)
Press 8x to select the Dual Channel Monitor.
(DCM)
6