SW-Stahl 62005SB Bedienungsanleitung Seite 8

U S I N G H E AT G U N
This product is very light and easy to use. The variable heat control allows for low to high working
temperature setting. Before plugging into the electrical outlet, make sure the power switch is in the
off position.
When ready to work set switch to on and set variable heat control to desired temperature settings.
Allow a minute or so or to reach its operating temperature.
This heat gun is designed with a built in a stand so it can be positioned in an upright (vertical) position
only, on any fl at, level surface. This frees both hands to easily shape mold materials.
PA I N T A N D VA R N I S H R E M OVA L
Turn on the gun and allow it to reach full heating power. Hold the nozzle 3" to 4" from the paint to be
moved. After short time, paint will soften and begin blistering. Do not overheat paint, as this will cause
buring and make the fi nish more diffi cult to remove. When stripping paint overhead, always use eye
protection.
Being scraping the paint off working from top to bottom. Use scrapers. Scrape with smooth, Even
strokes, warming the surface in front of the scaper by moving the gun slightly from side to side. If
paint is warmed properly, even thick layers can be removed in a single pass. Paint should come off in a
strip equal in width to the scraper blade.
Clean the edge of the scraper regularly to keep it clean and sharp
and to prevent paint from building up on the blade. Scrape the
paint as soon as it soften since it will quickly harden again.
Shaped or profi led surfaces can be stripped with a wire brush
after softening with the hot air jet.
Cover all surfaces not be heated with non-fl ammable material.
Never concentrate tool`s heat on a window panel or other glass
surface.
8
62005SB_manual_75030_de_en_roh.indd 8 62005SB_manual_75030_de_en_roh.indd 8 21.12.20 13:05 21.12.20 13:05