Technical Data - AEG EC 4831 Bedienungsanleitung, Garantie

(8)
You can pause play for a short moment and start it
again. If the button is pressed again, the track starts to
play again from the same position. To interrupt the BT-
connection, hold the button for a short moment. To re-
connect, push the button again.
(9)
push 1 x = P lays the current song from the beginning.
push 2 x = Skip to previous title.
push 3 x = Plays the song before that one etc.
(10)
With this button you can skip to the next title or the title
after that etc.
Cleaning
ATTENTION:
Do not submerge the appliance in water.
• Before cleaning, always remove the power plug.
• Clean the appliance with a moist cloth without ad-
ditional cleaning agents.
Troubleshooting
Error Cause
Appliance Appliance is
does not blocked "frozen".
respond to
controls.
No audio Speaker is not
signal with paired with the
Bluetooth audio source.
connection.
Volume too low.
Speaker Pairing does not
does not work.
connect.
Audio source is off. Turn on the audio
Speaker Bluetooth is turned
does not off on the audio
connect. source.
Bluetooth version
is not supported.
Error
High whis-
tling tone
when using
the micro-
phone.
No sound in
all operating
modes.

Technical data

Model: ....................................................................EC 4831
Power supply: ................................AC 100-240 V, 50/60 Hz
Power consumption: ................................................... 30 W
Rechargeable battery: ................................12 V 4000 mAh
Solution
Protection class: .................................................................II
Pull the power plug
Net weight: ...................................................approx. 6.9 kg
for approx. 10 sec.
Bluetooth
and set the power
Bluetooth support: ...........................................V2.1 + EDR
switch to "OFF".
Range (Class II): ..................................... approx. 10 metres
Turn on the appli-
Sending frequency: ................................. 2.402-2.480 GHz
ance again.
Protocols. .......................................................A2DP/AVRCP
Check whether the
The right to make technical and design modifications in
connection is active.
the course of continuous product development remains
If applicable, pair
reserved.
the speaker with the
audio source again.
Information on Compliance with
Turn up the volume
Guidelines
on the speaker.
Turn up the volume
The company ETV – Elektro-Technische Vertriebsge-
on the audio source.
sellschaft mbH hereby declares that the appliance
Check whether the
EC 4831 corresponds to the basic requirements and
audio source uses
the other relevant regulations of the R&TTE Guide-
the A2DP protocol.
line(1999/5/EG), the European Directive for electromag-
netic compatibility (2004/108/EG).
source.
Tested for operation in Germany.
Turn on the Blue-
tooth function on
the audio source.
Use a different
player.
Cause
Acoustic feedback. Use the microphone
The input level is
too low.
Charging time: .................................. approx. 10 hours
Operating time: .................................... up to 15 hours
English
39
Solution
outside of the
speaker wave radia-
tion zone.
- Turn up the volume
of the appliance on
the VOL-regulator
(2).
- Turn up the volume
on the external
player.
- Select the right
player source.
- Check whether the
connected appli-
ance is in the usual
playing mode.