Epson TM-U220 Serie Bedienungsanleitung Seite 17

ERROR (ERROR) LED is flashing or lit
❏ The print head temperature may be too high or low. Wait until the
❏ Make sure that the roll paper cover is properly closed.
❏ Types A and B: The autocutter blade is not in the normal position
❏ A paper jam has occurred. To remove the jammed paper, see the
❏ Turn off the power, wait several seconds, and then turn it on
Returning the autocutter blade to the normal position
1. Open the roll paper cover by using the tab, as shown in
2. Use a ballpoint pen or tweezers to turn the knob of the autocutter
Removing jammed paper
The print head becomes very hot during printing. Allow it to cool before
you reach into the printer.
1. Open the roll paper cover by using the tab, as shown in
2. If you have a
3. Remove the jammed paper.
4. Re-insert the roll paper and close the roll paper cover.
Downloaded from www.Manualslib.com
print head cools or warms and the printer resumes printing
automatically.
and the autocutter is locked up. If it is a simple lock-up, the error is
corrected automatically. If not, see the instructions below to return
the blade to the normal position manually.
instructions below.
again. If the error remains, contact your supervisor or a qualified
service person.
illustration .
H
in the direction indicated by the arrow until you see a round shaft
in the hole, as shown in illustration
CAUTION:
illustration .
H
Type A
the unit by using the unit open lever, as shown in illustration
manuals search engine
.
P
printer, remove the take-up spool and open
English
TM-U220 User's Manual 9
I .