Manual Address Allocation Via Central Control Unit; Automatic Address Allocation With Data Carrier; Manual Ad Dress Allocation Via Iq Deviceinstaller - Honeywell luminAXS Serie Montage, Anschluss, Anleitung

Mounting and Connection Instructions Reader series "luminAXS"
7.1. 4

Manual address allocation via central control unit

Enter the serial number of a new
control unit. The controller
received serial number
address.
Programming
Enter serial
number
of the operating unit
plus adress
7.1. 5

Automatic address allocation with data carrier

The address allocation mode must be
activated.
Hold an MIFARE data carrier in the reading
range. The reader now transmits the
number to the controller
allocates a free address to this number and
transmits the serial
address back to the
interval, the reader
permanently.
Acknowledgement: After approx. 1 sec.
the LEDs indicate the allocated address
(see 7.1.3).
7.1.6 Manual address allocation via IQ DeviceInstaller and configuration tool usb
Set up according to Sect. 4.2.
Enter the address in the configuration mode. The address is stored in the reader.
A TTENTION A plausibility check is not possible
The address is stored in the reader.
If the reader is later connected with the EU/control panel, the entered address is then sent to the
EU/control panel together with the reader serial number and stored there.
The address can now be confirmed in the display mode (see 7.1.3)
reader plus the desired address when programming the central
transmits the serial number plus the address to the
corresponds with the number defined in the reader,
Serial number
+ address
serial
. The controller
number plus the
reader . After a brief
stores the address
:
Serial number
+ address
EU
Panel
Serial number
EU
Panel
allocates a free
address to the
serial number
Serial number
+ address
!
39
reader . If the
the reader stores the