Activate Adress Allocation Mode; A Dress D Indicator - Honeywell luminAXS Serie Montage, Anschluss, Anleitung

38
7.1.2 Activate address allocation mode
1 2 3
LED LED DUO LED
green yellow only green
Activate address allocation mode via the programming (controller).
The address allocation mode at the reader is indicated by the flashing DUO-
LED green (lights up briefly followed by a long pause).
Switch off the address allocation mode via the programming.
7.1.3 Address indication
The address allocation mode must be activated.
The address indicator is for monitoring newly defined
addresses or for a later control.
LED function:
- LED green (1) = Tens digit
Each flash indicates the tens digit of the allocated address.
- LED yellow (2) = Ones digit
Each flash indicates the ones digit of the allocated address.
Example:
Indication for address 24:
- Tens digit = 20: LED green (1) flashes 2x
- Ones digit = 4: LED yellow (2) flashes 4x = 4
The address allocation mode is then displayed in the DUO-LED green (3).
Repeat address indication:
Hold the data carrier briefly in the reading range of the reader. A brief acoustical acknowledgement
confirms the request to indicate and restarts the indication sequence.
The DUO-LED (3) remains dark when the address is indicated.
Mounting and Connection Instructions Reader series "luminAXS"
1 2 3
LED LED DUO LED
green yellow only green
Tens digit
Units digit yellow)
1 2 3
1
4 5 6
2
7 8 9
3
3
0
r
(gr een )
1
1 2 3
2
3
(
LED green
LED yellow
F
DUO-LED
i
only green
DOU-LED green
Tens digit (gr een )
Units digit yellow) (
This example shows
address 24