Temperature Probe; Temperature Unit - Vimar By-me Benutzerhandbuch

Settings
NOTICE: It is not possible to stop the touch calibration function. Once started it must be completed.
To exit the menu touch
2.4 Favourite Application.
Used to set the start-up screen you want to be displayed.

Main Menu
Scroll with
lastly by touching
The control panel confirms the operation has been completed.
2.5 Screen saver.
Used to set the time of inactivity at the end of which the control panel activates the screen saver and cuts off the
display backlighting.

Main Menu
-Touching
-Touching
saver.
With
the operation carried out.
The activation time of the screen saver set by default is equal to 1 and a half minutes.
NB: If the screen saver is disabled, after 1 and a half minutes only the display backlighting is cut off.

2.6 Temperature Probe

Once the installer has correctly configured, connected and enabled the probe, it is possible to view the measured
temperature.

Main Menu
The display will show a screen that shows and periodically updates the current temperature measured by the
sensor. The temperature value is given in the unit of measurement configured on the device (see the following
paragraph 2.7).
Touching

2.7 Temperature Unit

Used to select the temperature unit from degrees Celsius or degrees Fahrenheit.

Main Menu
40
Downloaded from www.Manualslib.com
Exit
.
 
Setup Settings Favourite Application
upwards or downwards through the menu items and select the desired application; confirm
Save .
 
Setup Settings Screensaver
Off
disables the screen saver.
Delay
enables setting the inactivity time at the end of which the control panel activates the screen
upwards or downwards select the desired value then touch
Temperature Probe
Menu takes you back to view the main menu of the control panel.
 
Setup Settings Temperature Unit
manuals search engine
Set ; the control panel confirms