Herunterladen Inhalt Inhalt Diese Seite drucken

Montage Motor; Montage Du Moteur - eRCMarket robbe Schluter Millennium 90 II SE Bedienungsanleitung

Inhaltsverzeichnis

Werbung

D
Baustufe: 8

8.3 Montage Motor

Hinweis:
Bei Montage eines Motor mit einem
M8 Gewinde auf der Kurbelwelle,
ist zur Befestigung des Anlaßtopfes
die beiliegende Mutter (S0040) zu
verwenden.
Bei Einsatz eines OS-Motors sind die
separat zu erwerbenden Bundmuttern
1/4' [S4541] bzw.
5/16' [S4543] einzusetzen.
Hinweis:
Bei Motoren mit Kurbelwelle ø9,52
mm wird der Konus (S3193)
verwendet
S4152
M 3 x 5
8x
S 0019
M 3 x 5
2x
8 . 4 E i n b a u
Motorträger und Kupplungsglocke
Hinweis:
Vor Einsatz der Motoreinheit,
Vergaseranschlußschlauch an den
Tank anschließen.
Hinweis:
Motoreinheit bis zum Anschlag in die
Kupplungsglocke einführen
S0002
4.3 x 9 x 0.8
4x
S0089
M 4 x 14
4x
S0066
4x
S0033
M 4 x 10
4x
Downloaded from
www.Manualslib.com
8.3 Fitting the engine
Note:
If you are using any motor with an
M8 crankshaft thread, use the nut
supplied (S0040) to retain the starter
cup.
If you are using an OS engine use
a 1/4" flanged nut [RCRO-105] or a
5/16" flanged nut [RCRO-019], both of
which are available separately.
Note:
If your engine has a 9.52 mm Ø
crankshaft use the taper collet
(S3193).
Motor,
8.4 Installing the engine, engine mount
and clutch bell
Note:
Before attempting to run the engine
don't forget to connect the carburettor
feed line to the fueltank.
Note:
Slide the motor assembly into the
clutch bell as far as it will go.
4.3 x 12 x 1
manuals search engine
Stage: 8
GB
47
F
Stade: 8

8.3 Montage du moteur

À noter:
Lorsque vous installez un moteur avec
un filetage M 8 sur le vilebrequin, pour
fixer le bouchon de démarrage, utiliser
l'écrou joint (S0040).
Avec un moteur OS il faut installer les
écrous à épaulement 1/4" [S4541] ou
5/16" [S4543] à acquérir par ailleurs.
À noter:
Avec les moteurs munis d'un
vilebrequin de Ø 9,52 mm utiliser le
cône (S3193).
8.4 Installation du moteur, support-
moteur et cloche d'embrayage
À noter:
Avant d'installer l'unité de
motorisation, raccorder la durite du
carburateur au réservoir.
À noter:
Engager le bloc moteur jusq'à la butée
dans la cloche d'embrayage.

Werbung

Inhaltsverzeichnis
loading

Diese Anleitung auch für:

Se 2870-90

Inhaltsverzeichnis