3B LASER PEN 200 mW Gebrauchsanleitung Seite 23

A single frequency can be selected as follows:
When the value on the screen flashes, go to the respective frequency program by pressing the "+" or "-"key. Then
press the SET key for 2–3 sec. This gets you into the setting mode for the different frequencies. Use the "+/-" key to
select the desired frequency and confirm it with the SET key. When you press SET again, the selected frequency is
shown on the treatment screen.
Setting a freely programmable frequency:
Twenty memory locations FP1 to FP20 are available for freely programmable frequencies. When the value flashes,
press the "+" or "-" key to enter the frequency program FP. Keep the SET key pressed for 2–3 sec. to get to the "Pro-
grammable" screen on the display.
Keep the SET key pressed for 2–3 sec. to enter the frequency setting mode.
You can set the desired frequency (1–9,999.99 Hz) with the "+/-" and SET keys. First the thousands digit, then the
hundreds digit, etc. Once the desired frequency has been set, confirm with the SET key (keep pressed for 2–3 sec.).
The frequency is now transferred to the treatment screen on the display (at first as a flashing value). The frequency
is stored with the SET key and displayed on the screen.
A value that has been set remains in the memory until it is overwritten by another frequency.
After the treatment mode has been set, the display changes to the following screen:
The energy dose rate can be changed with the "+/-" keys. The SET key confirms the selected value. The selected
dose automatically appears as a flashing value in the display as the therapy time required for the selected output.
Press the SET key to confirm the value. Now the required therapy time is flashing. It can be confirmed with the SET key.
Please note: Changing the therapy time with the "+/-" keys also changes the dose required for this therapy time
depending on the selected output.
Possible settings for the therapy time are:
10 sec.–1 min. in 20-sec. increments
1 min.–20 min. in 1-min. increments
Last revised 16.02.12
Downloaded from www.Manualslib.com
100mW
M
100mW
M
manuals search engine
Programmable
FP1: xxx Hz
Frequency x
xxxx.xx Hz
120.0J
CW
20:00
CW
25