Toro Power Plex 51132 Bedienungsanleitung Seite 17

Replacing the String
1. Remove the battery.
2. Remove the spool; refer to
(page 14).
Figure 16
1. Spool
2. Anchor slot
Note:
Remove any old string remaining on the
spool.
3. Each side of the spool accepts approximately
3.6 m (12 ft) of string. Use only 2 mm (0.08
inch) diameter monofilament string.
Note:
Do not use any other gauge or type of
string, as this could damage the trimmer.
4. Insert the string into the anchor hole in the upper
part of the spool
onto the spool in the direction shown by the
arrows on the spool.
5. Place the string in the slot on the upper spool
flange, leaving about 152 mm (6 inches)
extended beyond the slot.
Note:
Do not overfill. After winding the string,
there should be at least 6 mm (1/4 inch) between
the wound string and the outside edge of the
spool.
6. Replace the spool and the spool retainer; refer
to Replacing the Spool (page
Replacing the Spool
(Figure 16). Wind the string
14).
Storage
Important:
Store the tool, battery pack, and
charger only in temperatures that are within the
appropriate range; refer to
10).
Important:
If you are storing the tool for a year
or longer, remove the battery pack from the tool
and charge the battery pack until 2 or 3 LED
indicators turn blue on the battery. Do not store a
fully charged or fully depleted battery. When you
are ready to use the tool again, charge the battery
pack until the left indicator light turns green on
g203888
the charger or all 4 LED indicators turn blue on
the battery.
•
Clean all foreign material from the product.
•
Store the tool, battery pack, and battery charger
in a well-ventilated place that is inaccessible to
children.
•
Keep the tool, battery pack, and battery charger
away from corrosive agents such as garden
chemicals and de-icing salts.
•
To reduce the risk of serious personal injury, do
not store the battery pack outside or in vehicles.
•
Store the tool, battery pack, and battery charger
in an enclosed clean, dry area.
Preparing the Battery Pack
for Recycling
Important:
Upon removal, cover the terminals of
the battery pack with heavy-duty adhesive tape.
Do not attempt to destroy or disassemble the
battery pack or remove any of its components.
Lithium-ion battery packs must be recycled
or disposed of properly at the nearest battery
recycling facility.
15
Specifications (page
For more information on recycling lithium-ion
battery packs and to locate the battery
recycling facility closest to you, visit
www.Call2Recycle.org (US and Canada only).
If you are located outside of the US and
Canada, please contact your authorized Toro
distributor.