Yealink SIP-T48G Schnellstartanleitung Seite 7

Configuring Your Phone
Configuring via web user interface
Accessing the web user interface:
1. Press the OK key when the phone is idle to obtain the IP address of the phone.
2. Open the web browser on your computer, enter the IP address into the address bar (e.g.,
"http://192.168.0.10" or "192.168.0.10") and then press the Enter key.
3. Enter the user name (default: admin) and password (default: admin) in the login page and
click Confirm.
Network Settings: Click on Network->Basic->IPv4 Config
You can configure the network settings in the following ways:
DHCP: By default, the phone attempts to contact a DHCP server in your network to obtain its valid
network settings, e.g., IP address, subnet mask, gateway address and DNS address.
Static IP Address: If your phone can not contact a DHCP server for any reason, you need to
PPPoE: If you are using an xDSL modem, you can connect your phone to the Internet via PPPoE
mode. Contact the ITSP for the PPPoE user name and password.
Note: The wrong network settings may result in the inaccessibility of your phone and may have an impact on
the network performance. Contact your system administrator for more information.
Account Settings: Click on Account->Register->Account X (X=1, 2, 3, 4, 5, 6)
Parameters of the account:
Register Status:
Line Active:
Label:
Display Name:
User Name:
Register Name:
Password:
Server Host:
Register status icons on the touch screen:
(Green) Registered
Note: Check with your system administrator if any error appears during the registration process or a specific
configuration is required for your registration.
Configuring via phone user interface
Network Settings:
When the phone is idle, tap
Webserver Type/802.1x Settings/VPN to configure the network.
Account Settings:
When the phone is idle, tap
account.
Note: For more information on account parameters, refer to Configuring via web user interface.
Downloaded from www.Manualslib.com
configure the IP address, subnet mask, gateway address, primary DNS
address and secondary DNS address for the phone manually.
It shows the register status of the current account.
You can select Enabled/Disabled to enable/disable the account.
It is shown on the touch screen to identify the account.
It is shown as caller ID when placing a call.
It is provided by ITSP for registration (required).
It is an authenticated ID for authentication provided by ITSP (required).
It is provided by ITSP for registration (required).
It is provided by ITSP for registration (required).
(Gray) Register Failed
->Advanced (password: admin)->Network->WAN Port/VLAN/
->Advanced (password: admin)->Account to configure the
manuals search engine
(Green and Flashing) Registering
E
N
G
L
I
S
H
3