Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
ENGLISH
WHITE OR BROWN MINI MAGNETIC CONTACT WITH SHOCK DETECTOR
LED indicator
In normal operating mode, the LED is off, except for the following situations:
When the tamper switch of the device is opened
When the battery of the device is flat
When the device is in Test mode
The LED does not flash if the tamper switch and the battery of the device are working normally and not in Test mode.
The LED flashes to indicate that a signal is being transmitted and flashes rapidly twice when it receives a recognition signal from
the control unit.
Jumper
Management of alarms generated by opening of the magnet
The detection of the alarm generated by the opening of the magnet can be enabled or disabled by jumper JP1:
If the jumper is ON (the jumper is inserted on the two pins), detection is deactivated and the shock/vibration alarm
remain enabled.
If the jumper is OFF (jumper removed or "arranged" on a pin), detection is enabled (default setting).
Important note: insert the jumper on JP1 in case you are using the device as shock detector only.
Management of alarms generated by shocks/vibrations
The detection of the alarm generated by impulses caused by shocks or vibrations can be configured as follows.
Single pulse detection
The alarm is generated by the detection of a single pulse exceeding the set threshold.
Multiple pulse/sum of vibrations detection
The alarm is generated by the detection of at least one of the following two conditions:
I.
When 3 pulses are detected in a time interval of less than 20 seconds.
II.
When the accumulation of vibrations detected in a time interval of less than 2 minutes exceeds the set threshold.
The modes described are determined by jumper JP3:
If the jumper is ON (the jumper is inserted on the two pins): Single pulse detection (default setting)
If the jumper is OFF (jumper removed or "arranged" on a pin): Multiple pulse/sum of vibrations detection
QUICK GUIDE
DC600S - DC600S/BR
1.
LED Indicator/Learning/Test Button
2.
Cover fixing screw
3.
Wall-mounting hole arrangement
4.
Tamper switch
5.
Battery insulation
6.
Jumper for selecting detection type (JP3)
7.
Jumper for selecting detection sensitivity (JP4, JP5)
8.
Jumper for selecting magnet use mode (JP1)
9.
Battery
10. Magnet
11. Magnet fixing screw hole
12. Magnet spacer
Jumper. Default position
DS80MM1L-002
Werbung
Inhaltsverzeichnis
