Yamaha RM-CR Installationshandbuch Seite 21

Network specifications
[Dante/PoE] port
Network ports
[SETUP] port
Input/output characteristics
Input Actual Load
Terminal Impedance
MIC IN
2.2 kΩ
1, 2
AUX IN
20 kΩ
L, R
Output Actual Source
Terminal Impedance
AUX OUT
1 kΩ
L, R
SP OUT
1 kΩ
L, R
Dante Audio/Dante Control, remote control, WebUI, PoE+ supported
Cable requirements: CAT5e or higher, STP
Corporate Network, remote control, SIP, WebUI
Cable requirements: CAT5e or higher, STP
USB2.0 micro, Network Class, WebUI, fixed IP
Cable requirement: USB cable (A-micro B type)
For Use With
Nominal
50 – 600 Ω
1 kΩ
For Use With
Nominal
10 kΩ
10 kΩ
Input Level
Max.
Nominal
Before Clip
−46 dBu −26 dBu
−14 dBV +6 dBV
Output Level
Max.
Nominal
Before Clip
−14 dBV +6 dBV
−14 dBV +6 dBV
RM-CR Installation Manual
Connector
XLR-3-31
(Balanced)
RCA PIN
Connector
RCA PIN
RCA PIN
21