Herunterladen Diese Seite drucken

Technical Characteristics - De Dietrich AD250 Montageanleitung

Systemfühler

Werbung

English
1
Description
The system sensor is used to measure the temperature of a buffer
tank, a cascade flow or a second DHW tank.
2

Technical characteristics

Length of the sensor cable: 5 m
Values of water sensor
Temperature
10°C
20 °C
25 °C
30 °C
40 °C
50 °C
60 °C
70 °C
80 °C
90 °C
3
Assembly and electrical connection
Only qualified professionnals may carry out electrical
connections, always with the power off.
1. Place the sensor in the sensor tube on the appliance concerned.
2. Accessing the boiler PCB SCU.
Refer to the installation and maintenance instructions of the
boiler (see chapter: Electrical connections)
3. Connect the sensor to the terminal block (S SYST).
Under no circumstances must sensor cables (very low
voltage) be placed in cable ducts or channels carrying
cables supplying 230 V. Furthermore, a minimum distance
of 10 cm should be kept between cables supplying very
low voltage and cables supplying 230 V
23/03/2009 - 300020442-001-A
Resistance
19 691 Ω
12 474 Ω
10 000 Ω
8 080 Ω
5 372 Ω
3 661 Ω
2 535 Ω
1 794 Ω
1 290 Ω
941 Ω
Nederlands
1
Beschrijving
Met de systeemvoeler kan de temperatuur van een bufferboiler, een
cascade-aanvoerleiding of een tweede SWW-toestel gemeten
worden.
2
Technische gegevens
Lengte van de voeler kabel: 5 m
Weerstandswaarden van de watervoeler
Temperatuur
10°C
20 °C
25 °C
30 °C
40 °C
50 °C
60 °C
70 °C
80 °C
90 °C
3
Montage en elektrische aansluiting
De elektrische aansluitingen moeten door een erkend
installateur tot stand worden gebracht.
1. Zet de voeler op zijn plaats in de dompelbuis van het betreffende
apparaat.
2. Ga naar de elektronische printplaat SCU van de ketel.
Zie de installatie- en onderhoudshandleiding van de ketel
(zie het hoofdstuk: Elektrische aansluitingen)
3. Sluit de voeler aan op de klemmenstrook (S SYST).
Plaats nooit in eenzelfde buis de draden van een voeler
(zeer lage spanning) samen met de draden met een
voeding van 230 V. De afstand tussen beide stroomdraden
moet minimaal 10 cm bedragen
AD250
Weerstand
19 691 Ω
12 474 Ω
10 000 Ω
8 080 Ω
5 372 Ω
3 661 Ω
2 535 Ω
1 794 Ω
1 290 Ω
941 Ω
3

Werbung

loading