Setting Up Your Camera; Selecting The Lens; Fixed Lens; Vari-Focal Auto Iris Lens - Honeywell HCM574L Bedienungsanleitung

Setting Up Your Camera

Figure 3 shows the factory set DIP switch settings.
Automatic Gain Control (AGC) is set ON.
Figure 3

Selecting the Lens

Fixed Lens

Set the AES/AI switch on the rear of the camera (see
Figure 3) to AES.

Vari-focal Auto Iris Lens

Vari-focal Auto Iris lenses (Direct Drive [DC] or Video Drive
[VSD]) are connected to the camera via a 4-pin square
socket located at the side of the camera. Set the AES/AI
DIP switch to AI.
To set a different exposure, see
(BLC) on page

Direct Drive (DC) Lens

1. Set the VSD/DC switch on the rear of the camera to
DC. Set the AES/AI DIP switch to AI.
2. Slowly turn the IRIS LEVEL potentiometer until the
picture on the monitor is as clear as possible and is not
too bright.
Rev 2
Factory Set DIP Switch Settings
IRIS
LEVEL
VIDEO
CLASS 2 ONLY
IRIS
V-PH
LEVEL
PWR
VSD
AES AI
OFF BLC
OFF AGC
INT LL
DC
5.
Low Voltage version shown
AES
OFF
OFF
INT
LEGEND
Backlight Compensation
4
VSD
AI
BLC
AGC
LL
DC
= ON
= OFF
G-113078-002
02/07