Auto White Balance Control (Awc); One Push Lock; Synchronization Selection (Ll/Int) - Honeywell HCC334L Bedienungsanleitung

Auto White Balance Control (AWC)

This mode covers a wider range of 2000°K to 10000°K and
performs at a faster operating speed than ATW mode. This
mode is typically used for outdoor applications or where
variable lighting conditions exist.

One Push Lock

Press PUSH LOCK on the rear of the camera to calibrate the
white balance for the current scene. This mode is typically
used for scenes with constant lighting conditions.

Synchronization Selection (LL/INT)

This switch selects the synchronization mode of the camera.
When the camera is connected to an AC supply, the Line
lock (LL) mode is used to lock the camera's frame rate to the
frequency so that each camera in the system is triggered at
the same point on the supply's AC cycle. The default setting
is LL.
WARNING!
Rev 3
The LL/INT switch must be set to INT
when operating from 12 VDC.
V-PH
PUSH IRIS
LEVEL
LOCK V-PH
PWR
EE
AES
OFF
+ -
DC 12V
GND
AC 24V
VIDEO
L/L
ME
AI
BLC INT
FL
VSD
AGC
WB3
WB2
WB1
DC
7
L/L
INT
G-113077-002
01/07