Troubleshooting Table - hanseatic HGT14283E Gebrauchsanleitung

Page EN-22

Troubleshooting table

Troubleshooting table
Malfunctions can occur in all electrical appliances. This does not necessarily mean
there is a defect in the appliance. For this reason, please check the tables to see if you
can correct the malfunction.
WARNING
Risk of electric shock in case of improper repair!
Never try to repair a defective or suspected defective appliance yourself. You can put
your own and future users' lives in danger. Only authorised specialists are allowed to
carry out this repair work.
Problem Possible cause
Compressor off, No electricity to socket.
light off.
Mains plug is loose.
Compressor off, Temperature controller (11)
light on. is set to 'OFF'.
Desired temperature has
been reached.
Appliance cools The temperature controller
too quickly. (11) is set too high.
The appliance The temperature controller
doesn't cool suffi- (11) is set too low.
ciently.
Lid not tightly closed or lid
seal is not completely tight.
The appliance is near a heat
source.
Food has been stored warm. Only store cooled foods.
Too many goods frozen.
Ambient temperature too low
or too high.
Compressor seems defec-
tive.
Solutions, tips, explanations
Check the socket with another appliance.
Check the fuse.
Check the tightness of the mains plug.
Turn the temperature controller to a higher
position (see "Setting the temperature" on
page EN-12).
Further cooling not required. When the in-
side temperature increases, the compres-
sor automatically switches on again.
Select a lower setting (see "Setting the
temperature" on page EN-12).
Select a higher setting (see "Setting the
temperature" on page EN-12).
See 'Checking and cleaning the lid seals'
on page EN-16.
Place insulation plate between the appli-
ances or change location.
The maximum freezing capacity is shown
on the type plate.
Adjust the ambient temperature to the
climate category (see "Intended use" on
page EN-5).
Set the temperature controller to "6". If the
compressor does not switch on within an
hour, please contact our service depart-
ment (see page EN-24).