Attaching The Transport Castors; Cleaning Before Use; Connecting The Appliance To Electricity - hanseatic HGT14283E Gebrauchsanleitung

Attaching the transport
castors
Four transport castors (b) come supplied with
the appliance, which you can screw onto the
bottom of the freezer if desired.
1. To do this, tilt the chest freezer and lean it
against a wall.
(7)
2. Unscrew the screw feet (7) entirely.
(c)
(b)
3. Use the screws (c) to screw the transport
castors(b) into the pre-drilled threaded
holes on the bottom of the appliance.

Cleaning before use

Wipe the interior with vinegar water before
using the appliance for the first time. Then
wipe it out with clean water and dry all of the
parts off afterwards.
First use
Connecting the appliance to
electricity
WARNING
Risk of electric shock!
Touching live parts may result in severe
injury or death.
When positioning the appliance, en-
■
sure the supply cord is not trapped
or damaged. Do not kink the supply
cord or lay it over sharp edges.
Do not connect to a timer or a sepa-
■
rate remote-controlled system for dis-
tance monitoring and control.
Do not locate multiple portable sock-
■
et-outlets or portable power supplies
at the rear of the appliance.
Power Run Alarm
(8) (9) (10)
1. Turn the temperature controller (11) to
'OFF'.
2. Connect the mains plug to a properly in-
stalled and easily accessible socket (see
"Technical specifications" on page EN-26).
The Power indicator light (8) illuminates.
The light (2) is switched on when the lid is
opened.
3. Turn the temperature controller (11) to a
middle value.
The Run (9) and Alarm (10) indicator
lights illuminate. The appliance will start
freezing.
4. Wait three to four hours before adding
frozen food for storage. With a very high
ambient temperature, for example, in the
summer, you should wait more than four
hours before storing food.
Page EN-21
5
6
4
OFF
3
1
2
(11)