Change Response Time Of Water Flow; Turn On/Off The Automatic Cleaning Cycle; Turn On/Off The Light Pulse; Turn On/Off The Beep - Miscea Classic Anleitung

3.5

Change response time of water flow

Press the «DOSE» button. The faucet shows a white light onto the «Water» segment.
With the «+» and «-» buttons the response time of the water flow can be changed.
The selected setting is automatically stored after 10 seconds or when the «2» button
is pressed.
3.6 Turning on/off the automatic cleaning cycle
Press the «CLEAN» button for 3 seconds. The IR sensors and the LED's are now in
standby mode. To get out of standby mode, the «CLEAN» button needs to be
pressed again for 3 seconds. The standby mode will not work if the faucet gets no
power from the mains power supply.
3.7 Turning on/off the light pulse
Press the «PULSE» button. The light pulses are being turned on or off.
The selected setting is automatically stored after 10 seconds or when the «2» button
is pressed.
3.8 Turning on/off the beep tone
With the «+» button the beep tone can be switched on, with the «-» button the beep
tone can be switched off.
3.9

Resetting to default settings

To restore the default settings, press the «CLEAN» and the «PULSE» button simultaneously.
All segments show their own light colour for 2 seconds.
3.10

Replacing the batteries

To replace the batteries, when they have run out of power, see Fig. B.
8
15